GO Faster Go Further
Established since 2001
Secure Supplies Group
Electrolyzer,Tall,
Tube,Cell,Stanley,
Meyer
Note Cells always in Pairs and in Series David put 2 x 9 cell sets to make 18 tubes.
Note for Version 1 Wiring Clarification
electro1622 I have my tubes connected in parallel the central earth connector which connects ALL the inner tubes together makes it impossible to have them in series.
Yes For This Version 1985 to 86 8XA 9XB that is Accurate, statement but as Stan Evolved latter he learnt just as a Solar array has it cells in series with by pass diodes between the series pairs of 4 tubes he did the same for the same reasons,
so if each pair of 4 tubes ( cells) in series to balance the inner out tube resistance between the 8 pairs is by pass diodes so if 1 set pair fails or dad shorts or drags than others series pairs keep producing with out collapsing whole WFC WATER FUEL-Cell whether it is 8 10 or 12 cells in series pairs. in the 8xa 9xb,
9 tube type cell WFC WATER FUEL-Cell he had not learnt that yet 1985 to 1986 version . so you are right and it has 9 tubes in ARRELLE BUT NOT BEST WAY JUST ACCURATE REPLICATION OF VERSION 1 ,
but we know it is un balanced IN TERMS OF INNER AND OUT TUBE RESISTANCE and not best performance in terms of volume and reliability compared to his latter 11 cell WFC WATER FUEL-Cell 10 cells in series pairs and 1 heater tube. god speed. water is fuel Daniel Secure Supplies . Training Site for Stanley A Meyer working systems
Remember Cells Wired in Pairs . the 9th cell is not wired in it is for heater.
Cell assembly drawings
IGES.zip - 6478.88 kB
STL.zip - 13969.99 kB
SKP.zip - 29112.18 kB
OBJ.zip - 16786.02 kB
We also have Bus Bars to improve this and or tube/ vic connections
Home Builder Replications
9 Cell
The Critical InFo you Want
-
Outer tubes 1 inch diameter,
-
inner tubes 3/4 inch diameter
-
Thickness 1/16 inch
-
316 L Stainless Steel. or higher.
-
16 to 18 inches long 418 mm to 458 mm
-
Gap 1mm to 2mm
-
9 Tube sets ( 18 Tubes inner and outer)
-
Clear tube acrylic 600/610 mm Aprox or 24 inches
-
end caps
-
can 3d print end caps for spacing see thingiverse .com
-
allo lift base of tube from base of cell 2-3 inches
-
Diameter of tube holder 155 mm
-
Inside diameter of tube 156mm
-
Cell tube Outside diameeter 184 mm
-
tube Wall thickness 2.8 mm
-
can reson set end caps or mill from acrylic
-
Note make a acrylic flange don't tap into the cylinder not strong enough.
-
when bolt end caps. use this 3d end cap to get spacing right. can adjust in www.blender.com
http://www.thingiverse.com/thing:84135
From a Viewer
Stanley Meyer talks about charging water except water isnt dielectric
and the only way you can make water dielectric is to ionize it into OH-
alkaline water.
So did you know that by fire a UVC or x ray laser at water
the ionizing radiation will turn the water into OH- ionizing it so the great part
is now the ionized water will become conductive and dielectric
which means it can hold a charge unlike stable H2O.
Ionized water is just H2O except it is missing one
hydrogen molecule and is an ion now with a ph of 9 making it conductive
Hello thank you for your study and comment about Stanley A Meyer Working Technology.
The WFC water fuel - cell is a capacitor is is design to work with the distilled water
or water with out any salt or electrolytes the process is call voltrolysis , as it does not
have a dead short or heat cascade during non stop constant operation.
The Innovative patented method is to have a gates High vdc fed in to cell which charges cell with out any dead short. this charge build up in the WFC . This create a Inherent magnetism to polarized Water and keep water in a positive charged state When this occur water molecule is pulled apart. Once pulled apart the gases loose electrons further charging WFC, in a positive state nothing is ground in the call WFC so charge builds.
So the charged stays high this allows during the off time for the cell to keep producing.
this means we have a very very high efficiency when compared to dead short outdated electrolysis. By not have any dead short the water surface tension strengthens and providing temp is maintain low in the water below 27 c Nano bubble of _ charged unstable H and o build up in the water crating a nano bubble water fuel to study more and support and build or gain original parts from Stan GOD Speed People are learning Stan told the truth and all his technology is in use today and spreading.
meyers tubes.png | stan meyer tube cell fiormula.png2.png |
---|---|
IMGP0003.jpg | Bild 126.jpg |
s.png | ffff.png |
SMgenerator.jpg | Stanley Meyers Water Fuel CellStanley Meyers Water Fuel Cell |
Stanley Meyers Water Fuel CellStanley Meyers Water Fuel Cell | Stanley Meyers Water Fuel CellStanley Meyers Water Fuel Cell |
Stanley Meyers Water Fuel CellStanley Meyers Water Fuel Cell | Stanley Meyers Water Fuel CellStanley Meyers Water Fuel Cell |
Stanley Meyers Water Fuel CellStanley Meyers Water Fuel Cell | Stanley Meyers Water Fuel CellStanley Meyers Water Fuel Cell |
Stanley Meyers Water Fuel CellStanley Meyers Water Fuel Cell |
Cell Capacitence
Stanel Meyer Shows this formula in the Technical Brief
The capacitance formula reads as follows C= 0.2249*e*Area (Square In. of the area of your cells)/D (Distance is your Gap between you cells)* Eo (The dielectric of Water which Stan says is 78.54 I think the little (e) stands for the lenght of the cell
Home Builder Replications
7 Cell
Stanley Meyers Water Fuel CellStanley Meyers Water Fuel Cell | Stanley Meyers Water Fuel CellStanley Meyers Water Fuel Cell |
---|---|
Stanley Meyers Water Fuel CellStanley Meyers Water Fuel Cell | Stanley Meyers Water Fuel CellStanley Meyers Water Fuel Cell |
Stanley Meyers Water Fuel CellStanley Meyers Water Fuel Cell | Stanley Meyers Water Fuel CellStanley Meyers Water Fuel Cell |
Stanley Meyers Water Fuel CellStanley Meyers Water Fuel Cell | Stanley Meyers Water Fuel CellStanley Meyers Water Fuel Cell |
Stanley Meyers Water Fuel CellStanley Meyers Water Fuel Cell | Stanley Meyers Water Fuel CellStanley Meyers Water Fuel Cell |
Stanley Meyers Water Fuel CellStanley Meyers Water Fuel Cell | Stanley Meyers Water Fuel CellStanley Meyers Water Fuel Cell |
Stanley Meyers Water Fuel CellStanley Meyers Water Fuel Cell | Stanley Meyers Water Fuel CellStanley Meyers Water Fuel Cell |
Stanley Meyers Water Fuel CellStanley Meyers Water Fuel Cell | Stanley Meyers Water Fuel CellStanley Meyers Water Fuel Cell |
Stanley Meyers Water Fuel CellStanley Meyers Water Fuel Cell | Stanley Meyers Water Fuel CellStanley Meyers Water Fuel Cell |
Stanley Meyers Water Fuel CellStanley Meyers Water Fuel Cell | Stanley Meyers Water Fuel CellStanley Meyers Water Fuel Cell |
Stanley Meyers Water Fuel CellStanley Meyers Water Fuel Cell | Stanley Meyers Water Fuel CellStanley Meyers Water Fuel Cell |
Stanley Meyers Water Fuel CellStanley Meyers Water Fuel Cell | Stanley Meyers Water Fuel CellStanley Meyers Water Fuel Cell |
Stanley Meyers Water Fuel CellStanley Meyers Water Fuel Cell | Stanley Meyers Water Fuel CellStanley Meyers Water Fuel Cell |
Stanley Meyers Water Fuel CellStanley Meyers Water Fuel Cell | Stanley Meyers Water Fuel CellStanley Meyers Water Fuel Cell |
The Following Photo is a Prospective drawing of the ability to place a number of tubes in the buggy pressure tank version 111
103 water fuel cells @3/4 "